IBM System x iDataPlex dx340, Руководство по диагностике и обслуживанию

Страница: 170 / 196

6. Install the hard disk drive bracket and cable assembly (see “Removing and
installing a one-bay or four-bay hard disk drive bracket and cable assembly” on
page 108).
7. Reinstall the 2.5-inch hot-swap drive cage, if you removed one (see “Installing
a 2.5-inch hot-swap drive cage” on page 97).
8. Reinstall the hard disk drives, if you removed any (See “Removing and
installing a hard disk drive” on page 88).
9. Install the expansion enclosure, if you removed one (see “Installing an
expansion enclosure on a system-board tray” on page 74); otherwise, install
the system-board tray cover (see “Installing the system-board tray cover” on
page 122).
10. Install the system-board tray in the chassis (see “Installing the system-board
tray in a 2U chassis” on page 76 or “Installing the system-board tray in a 3U
chassis” on page 78).
Note: After you replace the system-board tray, you must program the thermal
profile that is used to regulate cooling within the chassis.
To program the thermal profile for the new system-board tray, complete the
following steps:
1. Locate the two-digit, alphanumeric thermal-profile code. The two-digit
code is printed on the thermal-profile label that is affixed to the top of the
original system-board tray.
2. Locate the replacement identification (RID) tag that is affixed to the top of
the new system-board tray and record the machine type (MT), serial
number (SN), and thermal-profile code on the tag.
3. (Trained service technician only) Refer to Retain Tip H193629 for the
instructions to program the thermal profile for the new system board.
154
System x iDataPlex dx340 Types 6385, 6386, 6389, 7831, 7832, and 7834: Problem Determination and Service Guide