IBM System Cluster 1350, Установка и обслуживание

Страница: 132 / 170

d. Secure the power cables to the tie-downs in the tray using cable ties, as
shown in Figure 21
3. Prepare the Power Management Module tray for installing in the cabinet
a. Retract the sliding bracket at the back of the tray. Retracting the bracket
allows you to slide the tray in from the rear of the cabinet
b.
Tighten one screw on each side of the sliding bracket to prevent the bracket
from extending as you slide the tray in the cabinet
c.
Install the clip nuts on the cabinet vertical rails in Slot 18. The clip nuts may
still be on the vertical rails after the tray was removed. Install four in front
and four in back, as shown in Figure 22 on page 115.
Figure 21. Mount power bricks onto Power Management Module tray
114
Installation and Service