IBM System Cluster 1350, Установка и обслуживание

Страница: 151 / 170

To create an Etherchannel issue the following commands:
conf t
int range <mode/port> - <port>
channel-group <id> mode desirable non-silent
end
To remove an Etherchannel issue the following commands:
conf t
int range <mode/port> - <port>
no channel-group
end
For the following command to work make sure all ports in the group are set up
identically.
conf t
int range <mode/port> - <port>
channel-group <id> mode desirable on
end
This command will generate an error message about port differences. Once the
command works, set it back to the desirable mode.
To turn off the spanning tree on ports going to Cluster and Storage Nodes issue
the following commands:
conf t
int range <mode/port> - <port>
switchport host
end
To see the VLAN setup issue the following command:
show vlan
To set the switch as the spanning tree root. Run the command once for each
VLAN:
conf t
spanning-tree <id> root primary
end
To set the switch as the spanning tree root secondary. Run the command once for
each VLAN:
conf t
spanning-tree <id> root secondary
end
See spanning tree root information on a port by port basis:
show spanning-tree brief
See Etherchannels that are up and running:
show etherchannel
Switch commands for 4006 running CATOS
To set up VLANs issue the following commands:
set vtp domain <string>
set vlan <2> name <management-network>
To assign ports to the VLAN issue the following commands:
set vlan <2> 2/1-10
Appendix D. Setting up network switches
133