IBM System Cluster 1350, Установка и обслуживание

Страница: 131 / 170

2. Unscrew the Power Management Module from the tray. The two mounting
screws are located in the outermost of the four holes on each side of the device.
3. Slide the Power Management Module out of the tray
Install the Power Management Module and tray into the
cabinet
1. If adding a Power Management Module, determine the cabinet location and
rack position of the module.
2. Mount the Power Management Module on the tray
a. Slide the Power Management Module onto the tray so that the two outside
holes on each side of the Power Management Module align with the two
outer-most holes on each side of the tray, as shown in Figure 20.
b.
Insert two screws on each side of the tray in the two outermost holes. Use
the screws that are packaged with the Power Management Module braces.
(You will not use the braces, but you need to use the screws.)
c. Plug the power cables into the Power Management Module. Route the
remote power cables for the Nodes out through the cable management slot
on the side of the tray, as shown in Figure 21 on page 114.
Figure 20. Mount Power Management Module onto Power Management Module tray
Chapter 20. Power Management Module replacement and configuration
113