IBM System Cluster 1350, Установка и обслуживание

Страница: 103 / 170

4. Verify that the console switch is turned on. After approximately 40 seconds, the
console switch will send out a message reading :
Avocent AutoView 1000R/2000R
Ready_Press any key to continue. Press any key to access the AutoView
1000R/2000R main menu.
5. Get the IP address of the TFTP server. If using the SolarWinds TFTP server the
IP address is shown in the lower right-hand corner of the server’s pane.
Otherwise you must extract the IP address using the OS tools.
6. Right click on Network Neighborhood and select the Properties tab.
7. On the Protocols tab select TCP/IP protocol
8. Select Properties and make note of the IP address.
9. If needed, assign the IP address for the console switch:
a.
In the terminal emulation window enter 1 to select Network Configuration .
b. Compare the IP address shown for the console switch to the IP address of
the TFTP server. The first three numbers of both IP addresses must be the
same, but the last number must be different. If the console switch IP
address is incorrect type 3 to select
IP address and then enter the correct
address.
c. Type 0 to exit the Network Configuration menu and follow the prompts on
the screen to upgrade the FLASH level on the console switch.
Replacement of NetBAY Advanced Connectivity Technology RCM
Detailed removal, replacement, and configuration information for the RCM is
available online at the following URL:
ftp://ftp.pc.ibm.com/pub/pccbbs/pc_servers_pdf/rcm_iug520.pdf
Chapter 13. KVM Switch replacement and configuration
85