IBM System Cluster 1350, Установка и обслуживание

Страница: 101 / 170

b.
Extend the monitor tray out the front of the cabinet to allow access for
installing the rails, as shown in Figure 11.
c. Slide the switch rails into the cabinet from the rear of the cabinet, as shown
in Figure 11.
d. Insert the mounting screws into the rear vertical cabinet rails, as shown in
Figure 11. Insert two screws on each side. Do not tighten the screws.
If you have difficulty with neighboring mounting screws of components
already installed, loosen these mounting screws then tighten once all of the
component rails are installed.
e.
At the front of the cabinet, place the cover brackets on the outside of the
cabinet vertical rails and insert the mounting screws, as shown in Figure 11.
Insert four screws on each side.
f.
Tighten the mounting screws in the cabinet vertical rails with a Phillips #3
screwdriver.
4.
Cable and power up the console switch.
Figure 11. Install switch rails into cabinet from the rear of the cabinet
Chapter 13. KVM Switch replacement and configuration
83