IBM System Cluster 1350, Установка и обслуживание

Страница: 121 / 170

b.
Slide the switch rails into the cabinet from the rear of the cabinet, as shown
in Figure 17. Slide the tray part way in and route the power cables and
Ethernet cables from the front of the cabinet. Route the cable through the
Cable Management Tab shown in Figure 16 on page 102.
c. Insert the mounting screws in the rear vertical cabinet rails, as shown in
Figure 17. Insert two on each side. Do not tighten the screws.
If you have difficulty with neighboring mounting screws of components
already installed, loosen these mounting screws then tighten once all of the
component rails are installed.
Figure 17. Install switch rails into cabinet from the rear of the cabinet
Chapter 17. Cisco Gigabit Switch replacement and configuration
103