IBM System Cluster 1350, Установка и обслуживание

Страница: 119 / 170

Chapter 17. Cisco Gigabit Switch replacement and
configuration
Contents
Installation procedure
To replace the Cisco Gigabit Switch, you must remove the rails from the cabinet.
Remove the rails from the cabinet
1. Remove the mounting screws from the front vertical cabinet rails and remove
the cover bracket.
2. Remove the mounting screws from the rear vertical cabinet rails.
3. Slide the rails out the rear of the cabinet.
Remove the Cisco Gigabit Switch from the rails
Unscrew the Cisco Gigabit Switch from the rails. There are four holes on each side
of the devices.
Install the Cisco Gigabit Switch and rails into the cabinet
1.
Mount the switch rails to the Cisco Gigabit Switch.
a.
Mount the rails so the Cable Management Tab is on the left rail, and the
holes in the Gigabit Switch align with the set of two large holes at the front
of the rail and the set of two large holes closest to the back of the rail, as
shown in the figure below.
© Copyright IBM Corp. 2003
101