IBM System Cluster 1350, Установка и обслуживание

Страница: 61 / 170

7. Select Software Selection and choose Default system. Then select Detailed
Selection
and make sure Network/Server is selected. Under System Boot
Configuration select Next.
8.
Reboot the node.
9. You can now configure the network using the values shown in the following
table:
Network
Name IP Range Netmask Network Broadcast Hostname
eth0
Management
Node 172.20.0.1 255.255.0.0 172.20.0.0 172.20.255.255 mgt.cluster.com
eth1
Management
Node 172.30.0.1 255.255.0.0 172.30.0.0 172.30.255.25 mgt1.cluster.com
eth2 (customer network)
Management
Node ?? ?? ?? ?? ??
After you have configured the network, network initialization will fail. To correct
this problem, update the Intel e1000 drivers and update SLES 7 or 8 to the latest
level kernel available.
Update the configuration files
Now that the Management Node can communicate with other devices in the
cluster take the following steps:
1. Update /etc/modules.conf with the following lines:
alias eth0 e1000
alias eth1 e1000
alias eth2 e1000
2. Edit or create the /etc/rc.config file and make sure it contains the following
directives:
#
# IP Addresses
#
IPADDR_0="172.20.0.1"
IPADDR_1="172.30.0.1"
IPADDR_2=""
IPADDR_3="
#
# Network device names (e.g. "eth0")
#
NETDEV_0="eth0"
NETDEV_1="eth1"
NETDEV_2=""
NETDEV_3=""
#
# Parameters for ifconfig, simply enter "bootp" or "dhcpclient" to use
# the respective service for configuration. Sample entry for ethernet:
# IFCONFIG_0="192.168.81.38 broadcast 192.168.81.63 netmask 255.255.255.224"
#
IFCONFIG_0="172.20.0.1 broadcast 172.20.255.255 netmask 255.255.0.0"
IFCONFIG_1="172.30.0.1 broadcast 172.30.255.255 netmask 255.255.0.0"
IFCONFIG_2=""
Chapter 6. Software installation
43