IBM SAN512B-6, Инструкция по установке, обслуживанию и эксплуатации

Страница: 76 / 286

9) Indian Ocean
10) Pacific Ocean
11) none - I want to specify the time zone using the POSIX TZ format.
Enter number or control-D to quit ?
v Enter tsTimeZone [houroffset [, minuteoffset]] command as follows:
– For Pacific Standard Time, enter
tsTimeZone -8,0
.
– For Central Standard Time, enter tsTimeZone -6,0 .
– For Eastern Standard Time, enter
tsTimeZone -5,0
.
Table 8. Example: tsTimeZone command parameter selection for the US time zones
Local time
tsTimeZone
parameter
(difference
from UTC)
Atlantic Standard -4,0
Atlantic Daylight -3,0
Eastern Standard -5,0
Eastern Daylight -4,0
Central Standard -6,0
Central Daylight -5,0
Mountain Standard -7,0
Mountain Daylight -6,0
Pacific Standard -8,0
Pacific Daylight -7,0
Alaskan Standard -9,0
Alaskan Daylight -8,0
Hawaiian Standard -10,0
v
Enter the
tsTimeZone
command followed by the time zone, such as
US/Pacific, US/Central, or US/Eastern as in the following example.
switch_99:Admin> tstimezone US/Pacific
System Time Zone change will take effect at next reboot
Synchronizing local time with an external source
About this task
Perform the following steps to synchronize the local time of the principal or
primary FCS device with that of an external NTP server.
Procedure
1.
Log into the device using one of the following methods:
v A serial console connection to the active CP blade. The active CP is indicated
by an illuminated blue LED on the blade front panel.
v A Telnet session using the chassis management IP address.
2. Log into the device using admin. If you have not changed the default password,
usepassword.
3. Enter the
tsClockServer
ipaddr command.
The ipaddr variable represents the IP address of the NTP server that the device
can access. This argument is optional; by default, the value is "LOCL".
52
SAN512B-6 Installation, Service, and User Guide