IBM SAN512B-6, Инструкция по установке, обслуживанию и эксплуатации

Страница: 148 / 286

Time and items required
The replacement procedure for the core switch blade takes approximately 30
minutes. The following items are required for the core switch blade replacement:
v Electrostatic discharge (ESD) grounding strap
v Workstation computer
v Replacement blade or filler panel
v #1 Phillips screwdriver
v QSFP transceivers (as needed)
v Optical cables (as needed)
Note: For information about the transceivers that are qualified for this device,
refer to Chapter 5, “Installing Transceivers and Cables,” on page 57.
Removing a core routing blade
About this task
Complete the following steps to remove the core routing blade.
Note: The device continues to operate while a core routing blade is being replaced.
Procedure
1. Remove the chassis door.
2. Check the blade power and status LEDs and port status LEDs on the front of
each blade to identify any possible problems.
3.
Before replacing a blade, establish a Telnet or console connection to determine
a failure and verify operation after replacement. Use the
switchShow
and
slotShow
commands to view the status of the blades.
4. Check for adequate cable slack. Ensure there is plenty of cable slack to remove
a blade without cable obstruction.
5. Ensure that the part number on the unit being replaced matches the
replacement part number. The
chassisShow
command displays information
about the blades, including part numbers (xx-xxxxxxx-xx), serial numbers, and
additional status.
6. Ensure that traffic is not flowing through the blade (port status LED should be
off) prior to disconnecting cables.
7. Disconnect all cables and remove transceivers from the blade.
8. Label and then disconnect cables from the faulty core routing blade.
9. Loosen the captive screws for both ejector handles on the blade using a #1
Phillips screwdriver. Loosening the screws initiates a hot-swap request and
disconnects power from the blade. The spring-loaded captive screws will pop
out from the slot .63 cm (.25 in.) when fully disengaged. Do not eject the blade
using blade handles until screws disengage from slot and the power LED is
off.
10. Grasp both ejector handles and simultaneously pull them away from the
center of the blade using equal pressure to approximately 45 degrees (fully
open). As you move the handles, you will hear connectors disengaging from
the backplane connector and possibly a slight popping noise. This is normal
and is due to the dense backplane. The blade will move out approximately
1.27 cm (.5 in.) from the slot when fully disengaged.
124
SAN512B-6 Installation, Service, and User Guide