IBM SAN512B-6, Инструкция по установке, обслуживанию и эксплуатации

Страница: 57 / 286

Procedure
1.
Ensure that the door is removed from the port side of the device. For
instructions, refer to the door removal and replacement procedures in your
device installation guide.
2. Orient the device (refer the following figure) and use a hydraulic lift to raise it
to the level of the trays.
3. If applicable, lock the wheels of the lift.
4. Slide the device into the trays until the front edge of the device is seated
against the front tray.
1 - Tray, front, mid-mount, chassis
2 - Tray, rear, mid-mount, chassis
5. Use three screws (Item 5) to attach each side of the rear tray to the device (refer
the following figure).
Note: The screw holes in the device walls have pem nuts on the inside surface.
Figure 12. Placing the device in the trays
Chapter 3. Mounting the Device
33