IBM SAN512B-6, Инструкция по установке, обслуживанию и эксплуатации

Страница: 69 / 286

For information about LED patterns, refer to Chapter 6, “Monitoring the
switch,” on page 69.
14.
Ground the chassis by attaching a ground wire from facilities ground to an
appropriate crimp connector and attaching the connector to the 2AWG
Panduit LCD2-14AF lug located to the left of the bottom fan assembly near
the bottom of the chassis.
Using HVAC/HVDC power cords
HVAC/HVDC power supply power cords, available from Brocade, are shipped
with an Anderson Saf-D-Grid
®
400 connector on the power supply end and three
unterminated 14 AWG UL 600V 90C wires with ring lugs on the power source end.
Power cord length is 6 m (19 ft. 8 in.). For connecting to a power source, attach
either an AC power plug to these wires that meets your facility and local code
requirements, or connect these wires to appropriate DC power terminal blocks.
The following table defines the function of the 14 AWG wires in the power cable:
Table 7. HVAC/HVDC power cable
Wire label Color Function
L+ Brown Return positive (+)
– Blue Negative (-)
PE Green with yellow stripe Earth ground (PE)
The Anderson Saf-D-Grid
®
connector on the power supply end of the cord is
keyed so that it only fits one way into the power supply. Note that the connector's
latch should be positioned under the connector and will latch when the power
cord connector is fully inserted into the power supply.
Chapter 4. Initial Setup and Verification
45
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
|||
|||
|||
|||
|
|
|
|
|
|