IBM Power System 5148-22L, Руководство пользователя

Страница: 50 / 204

6. Attach the electrostatic discharge (ESD) wrist strap. The ESD wrist strap must be connected to an
unpainted metal surface until the service procedure is completed, and if applicable, until the service
access cover is replaced.
Attention:
v Attach an electrostatic discharge (ESD) wrist strap to the front ESD jack, to the rear ESD jack, or to
an unpainted metal surface of your hardware to prevent the electrostatic discharge from damaging
your hardware.
v When you use an ESD wrist strap, follow all electrical safety procedures. An ESD wrist strap is
used for static control. It does not increase or decrease your risk of receiving electric shock when
using or working on electrical equipment.
v If you do not have an ESD wrist strap, just prior to removing the product from ESD packaging and
installing or replacing hardware, touch an unpainted metal surface of the system for a minimum of
5 seconds. If at any point in this service process you move away from the system, it is important to
once again discharge yourself by touching an unpainted metal surface for at least 5 seconds before
you continue with the service process.
7. Remove the drive from the static-protective package and place it on an ESD mat.
Installing a disk drive or solid-state drive in the 5148-21L, 5148-22L, 8247-21L,
8247-22L, 8284-21A, or 8284-22A system with the power turned on in Linux
Learn how to install a disk drive or solid-state drive (SSD) in a system with the Linux operating system
or Linux logical partition that controls the drive location powered on.
To install a disk drive or solid-state drive in a system, complete the following steps:
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is
connected to an unpainted metal surface. If not, do so now.
2. Choose from the following options:
v
If you are installing a disk drive in a system, continue with step 3.
v If you are installing an solid-state drive in an expanded function system, continue with step 12 on
page 35.
3. If the slot you want to use contains a drive filler, remove the drive filler from the slot.
To remove a filler from a base function system, complete the following steps:
a. Push the lock (A) on the handle of the filler in the direction that is shown in Figure 31 on page
33.
b. Hold the handle and pull out the filler from the slot.
32
Disk drives or solid-state drives