IBM Power System 5148-22L, Руководство пользователя

Страница: 42 / 204

h. In the Specify either physical location or resource name field, type the physical location that you
previously recorded in this procedure.
i. Select
2
(Install device) for the Action to be completed.
j. Set the time delay in minutes. For example, for one minute enter: 01 .
Note: You can set an appropriate time delay of 01 - 19 minutes to allow adequate time to access
the disk drive or solid-state drive.
k. Do not press Enter yet, first complete installing the disk drive or solid-state drive in the system,
drive enclosure, or an expansion unit.
5. Find the package that contains the new drive.
Attention:
Drives are fragile. Handle with care.
6. Attach the electrostatic discharge (ESD) wrist strap. The ESD wrist strap must be connected to an
unpainted metal surface until the service procedure is completed, and if applicable, until the service
access cover is replaced.
Attention:
v Attach an electrostatic discharge (ESD) wrist strap to the front ESD jack, to the rear ESD jack, or to
an unpainted metal surface of your hardware to prevent the electrostatic discharge from damaging
your hardware.
v
When you use an ESD wrist strap, follow all electrical safety procedures. An ESD wrist strap is
used for static control. It does not increase or decrease your risk of receiving electric shock when
using or working on electrical equipment.
v If you do not have an ESD wrist strap, just prior to removing the product from ESD packaging and
installing or replacing hardware, touch an unpainted metal surface of the system for a minimum of
5 seconds. If at any point in this service process you move away from the system, it is important to
once again discharge yourself by touching an unpainted metal surface for at least 5 seconds before
you continue with the service process.
7. Remove the drive from the static-protective package and place it on an ESD mat.
Installing a disk drive or solid-state drive in the 8284-21A or 8284-22A system with
the power turned on in IBM i
Learn how to install a disk drive or solid-state drive (SSD) in a system with the IBM i operating system
or IBM i logical partition that controls the drive location powered on.
To install a disk drive or solid-state drive in a system, complete the following steps:
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is
connected to an unpainted metal surface. If not, do so now.
2. Choose from the following options:
Device Concurrent Maintenance
Type the choices, then press Enter.
Specify either physical location or resource name.
Physical location:
U787A.001.1234567-P3-D4
or
Device resource name:
Specify action as 1=Remove device 2=Install device
Action to be performed . . . . . . . .: 2
Enter a time value between 00 and 19.
Time delay needed in minutes . . . . .: 01
F3=Exit F5=Refresh F12=Cancel
Figure 21. Example Device Concurrent Maintenance display
24
Disk drives or solid-state drives