Example of Sending a File from the Configuration Program
For example, suppose that this is the view of the software that is displayed by the
list command:
Boot Config
>
list
BANK A
BANK B
IMAGE - ACTIVE
IMAGE - AVAIL
CONFIG 1 - ACTIVE
CONFIG 1 - AVAIL
CONFIG 2 - AVAIL
CONFIG 2 - AVAIL
CONFIG 3 - NONE
CONFIG 3 - AVAIL
CONFIG 4 - NONE
CONFIG 4 - NONE
The Configuration Program sends a config file to BANK A, CONFIG 2. If you use
the restart router option of the Configuration Program's communications feature, the
2212 performs a reset immediately and reinitializes using the new configuration.
After these actions, the IBM 2212 configuration looks like this:
BANK A
BANK B
IMAGE - ACTIVE
IMAGE - AVAIL
CONFIG 1 - AVAIL
CONFIG 1 - AVAIL
CONFIG 2 - ACTIVE
CONFIG 2 - AVAIL
CONFIG 3 - NONE
CONFIG 3 - AVAIL
CONFIG 4 - NONE
CONFIG 4 - NONE
CONFIG 1 has become AVAIL and CONFIG 2 has become ACTIVE.
If the Configuration Program were now used to send down a new configuration to
the IBM 2212 and the file were not marked to be loaded at any specified time, the
view of the software in the IBM 2212 would look like this:
BANK A
BANK B
IMAGE - ACTIVE
IMAGE - AVAIL
CONFIG 1 - AVAIL
CONFIG 1 - AVAIL
CONFIG 2 - ACTIVE
CONFIG 2 - AVAIL
CONFIG 3 - AVAIL
CONFIG 3 - AVAIL
CONFIG 4 - NONE
CONFIG 4 - NONE
After this action, CONFIG 3 is AVAIL. The new configuration file has been loaded
in this location.
Note: You should exercise caution here because any on-board configuration
changes could result in overwriting the CONFIG 3 file. Because the
configuration file in CONFIG 3 was sent down without any time specified for
resetting the server, it is currently not in use. It can be overwritten either
when another file is sent from the Configuration Program or when a file is
saved using the write command from the command line interface. You can
use the copy command to move it to another location to protect it (see
“Copying a File Using the Copy Command” on page A-19) or use the lock
command to keep the configuration file from being overwritten.
A-26
2212 Install and Initial Config
Содержание IBM 2212-40H
