IBM IBM 2212-40H, Руководство по установке и первоначальной настройке

Страница: 45 / 90

Enter the port number. The range of port numbers supported
depends on the multi-port adapter type.
6. Make a note of the interface number to which this port is assigned
and the net number. If you configure a WAN interface and wish to
use a data-link type other than PPP, you must use the set data-link
data-link type command to change the data-link type to any of the
data-link protocols available on your IBM 2212 (frame relay, X.25,
and SDLC for example).
7. Enter at the
Config>
prompt net net number to access
interface-unique configuration commands. Refer to the Access
Integration Services Software User’s Guide for a description of the
supported interface commands.
8. Enter exit after configuring the interface.
9. Use the protocol command at the
Config>
prompt to configure
protocols on the interface. Refer to Volume 1 and Volume 2 of the
Access Integration Services Protocol Configuration and Monitoring
Reference for a description of the supported commands for each
protocol.
10. Type exit to get the
Config
>
prompt.
11. Repeat steps 3 on page A-6 through 10 if you have a multi-port
adapter and you want to have more than one interface defined on
the adapter.
12. Enter write to save your changes.
13. Press Ctrl-p to return to the OPCON (*) prompt.
14. Type restart at the OPCON ( * ) prompt.
Adding an Adapter at Initial Configuration
Question How do I add an adapter to the software configuration when the IBM
2212 is being initially configured?
Answer First, perform installation of the 2212 and install any additional adapters
into the 2212. (The section on 2212 FRU Exchange in the
IBM 2212
Service and Maintenance Manual describes the removal and
replacement procedure.)
When the IBM 2212 is initially installed, it does not have any software
configuration. The operating system will put you at the
Config only>
prompt.
1. Enter add device type of device
Note: These steps create only the interface. You must use the net
command to configure characteristics unique to that interface
(for example, T/R, Ethernet, PPP, FR, SDLC, X.25). You
also need to use the protocol command to configure
protocols on the interface. If you configure a WAN interface
and wish to use a data-link type other than PPP, you must
use the set data-link
data-link type command to change the
data-link type to any of the data-link protocols available on
your IBM 2212 (frame relay, X.25, and SDLC for example).
To see a list of device choices, type add device ?.
Appendix A. Common Tasks
A-7