IBM IBM 2212-40H, Руководство по установке и первоначальной настройке

Страница: 42 / 90

Accessing OPCON from the Bootstrap Menus
Question How do I access the OPCON command line interface from within the
bootstrap?
Answer From the Boot Sequence Selection Menu, select Normal Boot, then
select Issue Reset. The OPCON prompt
* is displayed after the system
boots.
The command line interface is described in the Access Integration
Services Software User’s Guide.
Accessing OPCON from SVC>
Question How do I access the OPCON command line interface from within the
service recovery function (
SVC>
)?
Answer From the
SVC>
prompt, type Bootmode, then select 3. Normal Boot
From Disk and press Enter. Next, type reboot and press Enter. The
OPCON prompt
*
is displayed after the system boots.
Navigating Through the OPCON Command Line Interface
Question How do I use the commands in the Command Line Interface?
Answer The structure of the interface is shown in Figure A-1 on page A-5.
The Access Integration Services Software User’s Guide describes the
entire command line interface. The basic prompts that you use are the:
¹
*
prompt, which is the OPerating CONsole (OPCON) prompt, the
initial entry point to the command line interface
¹
Config
>
prompt, which is used for configuration changes
¹
+
prompt, which is known as monitoring or GWCON.
¹
Config Only
>
prompt, which is used for initial configuration. The IBM
2212 boots to this prompt if it has not been configured. You cannot
access GWCON (
+
) from the
Config Only>
prompt.
The basic commands are:
¹
Type ? and press Enter at any time to view a list of possible
commands.
¹
Type exit and press Enter to return to the + prompt and to the
Config
>
prompt.
¹
Press the Ctrl-p keys to return to the
*
prompt.
A-4
2212 Install and Initial Config