IBM IBM 2212-40H, Руководство по установке и первоначальной настройке

Страница: 35 / 90

Chapter 4. Performing the Initial Configuration
If you have a 2212 with no configuration, or if you have cleared the 2212’s
configuration, you must perform the steps in this section before you can send an
existing configuration from the Access Integration Services Configuration
Program to the 2212. Refer to Chapter 3, “Accessing the 2212” on page 3-1 for
instructions on accessing the 2212's configuration software.
Note: Alternately, you can use the command-line interface to create a full
configuration. See the AIS Software User's Guide, AIS Using and
Configuring Features and AIS Protocol Configuration and Monitoring
Reference, Volumes 1 and 2 for more information.
Setting Up the 2212 Initial Configuration
Note: The following instructions assume that you have used the Access
Integration Services Configuration Program to create a full configuration and
have stored the configuration file on a workstation on the network. This is
the recommended method for configuring the 2212 as explained in “Full
Configuration” on page 4-3.
To perform initial configuration on the 2212, you must first establish access to the
2212. You can establish access either locally or remotely as described in “Access
Methods” on page 3-1. If your system administrator has filled out the Initial
Configuration Worksheet in the
2212 Access Utility Introduction and Planning
Guide, obtain that worksheet now to use as a guide when performing the tasks in
this section. Then:
1. Press the space bar to obtain the console.
2. At the
Config Only
>
prompt, use the add device command to configure the
primary LAN or WAN interface. This is the adapter in your 2212 that will
connect to the LAN/WAN of the workstation or server on which the 2212's
configuration data is located.
Note: The four integrated WAN ports on the system card do not need to be
added; they are added automatically by the Access Integration Services
software.
If you plan to use a WAN interface and want to use a data link type other than
PPP (which is the default) then you will need to use the
set data link
command to change the data link type.
3. At the Config only
>
prompt, type qconfig and press Enter to start the Quick
Configuration program.
4. Perform an initial configuration to establish the IP address and IP mask for the
primary LAN/WAN interface for the 2212 as follows:
a. Configure Bridging
1) Enter No to
Configure Bridging?
b. Configure Protocols
1) Enter Yes to Configure Protocols?
c. Configure IP

Copyright IBM Corp. 1998, 1999
4-1