IBM IBM 2212-40H, Руководство по установке и первоначальной настройке

Страница: 28 / 90

Figure 3-1. Local Terminal Connection to the EIA-232 Service Port
Figure 3-2. Remote Terminal Connection to the EIA-232 Service Port
SLIP Addresses
The default SLIP IP addresses are:
For the workstation:
10.1.1.3
For the IBM 2212:
10.1.1.2
For instructions about installing SLIP, refer to the documentation for your version of
TCP/IP.
Service Port Default Settings
These are the default settings for the serial port:
Speed 19.2 Kbps
Parity None
Data Bits 8
Stop Bits 1
The service port speed may be configured for the following bit rates; however, the
speed must match the speed configured for the ASCII terminal. See “Changing the
Service Port Speed” on page A-11 for instructions on setting the 2212 service port
speed.
Note: For the initial configuration of the 2212, you must use 19.2 Kbps. As part of
the initial configuration, you can change the line speed of the service port.
See “Changing the Service Port Speed” on page A-11.
¹
2400
¹
9600
¹
14 400
¹
19 200
3-2
2212 Install and Initial Config