IBM IBM 2212-40H, Руководство по установке и первоначальной настройке

Страница: 61 / 90

TFTP transfer of /hd0/sys0/encrypt.ld complete, size=1867 status: OK
TFTP transfer of /hd0/sys0/LMX.ld complete, size=1044 status: OK
Operation completed successfully.
Boot config>
7. Type the set command to cause the bank and config file that you just
transferred the code load or configuration data into to become active at the
next reload/restart. You will be prompted for the destination source bank and
configuration file. Until you reload the 2212, the state of the bank is pending.
8. Type reload if you transferred new operational code. Type restart if you
transferred a new configuration file.
TFTP File Transfer using the Service Recovery Interface (SVC)
Use the Service Recovery Interface (
SVC>
) to transfer new software onto the 2212
only if you are replacing the hard file or compact flash, or the software on both
banks A and B is corrupted and you are replacing it. To use TFTP at the
SVC>
prompt, follow these steps:
1. Access the
SVC>
prompt. See “Accessing the Service Recovery Prompt (SVC>)”
on page A-5.
2. Type interface to define the 2212 LAN interface and IP address over which to
transfer the files.
3. At the
SVC
> prompt, type TFTP and press Enter.
4. Specify whether you want to TFTP a software code load (load) or a
configuration file (config). You will be prompted for the rest of the information.
The following example shows a software code load.
‡ —
svc>tftp
-------BankA-------+---------- Description -------+------ Date -------+
IMAGE - PENDING 10 Feb 1998 17:46
CONFIG 1 - AVAIL 10 Feb 1998 17:46
CONFIG 2 - AVAIL 09 Jan 1998 10:40
CONFIG 3 - AVAIL 06 Jan 1998 15:46
CONFIG 4 - PENDING * 02 Jan 1998 11:51
+------ BankB -------+--------- Description ----------+------ Date -------+
IMAGE - AVAIL 03 Feb 1998 14:42
CONFIG 1 - AVAIL * 03 Feb 1998 14:43
CONFIG 2 - AVAIL 22 Jan 1998 13:43
CONFIG 3 - AVAIL 06 Jan 1998 17:25
CONFIG 4 - AVAIL 26 Jun 1998 09:48
+------------------------+--------------------------------+----
Load or Config?
Specify the server IP Address:
1.1.1.4
Specify the remote directory: /u/2212/swload
Enter destination bank : b
tftping load modules... please be patient.
ˆ ˜
5. Type the set command to cause the bank and config file that you just
transferred the code load or configuration data into to become active at the
next reboot. You will be prompted for the destination source bank and
configuration file. Until you reload the 2212, the state of the bank is pending.
6. Type reboot.
Appendix A. Common Tasks
A-23