IBM IBM 2212-40H, Руководство по установке и первоначальной настройке

Страница: 62 / 90

Transferring Files Using Zmodem
Question How do I use Zmodem to transfer operational code and configuration
files onto the 2212?
Answer
Access the SVC> prompt. From the SVC> prompt, type zmodem. You will
be prompted to specify the bank for the image files or the bank and the
config number for the configuration files that you transfer. The interface
for transferring is designed so that you cannot overwrite any ACTIVE
file.
For transfers via modem, each load module must be separately named
and transferred individually.
Note: When using Zmodem to transfer a multiple load module image
(several files ending in .ld), you must transfer each of the
modules one by one to get the entire load module image.
When an entire load image has transferred, the status of the
bank will change from CORRUPT to AVAIL. Transfer file LML.ld
first. Unless you see an information message
ERROR WRITING
FILE appear, assume each individual transfer has been
successful.
Updating the Bootstrap Code on System Card Flash
Question How do I update the bootstrap code stored on system card flash?
Answer
1. Access the
SVC>
prompt as described on page “Accessing the
Service Recovery Prompt (SVC>)” on page A-5.
2. Type the writeboot command to write the bootstrap to system card
flash from the specified software load bank.
3. Type reboot.
Updating the Operational Code
Question How do I update the operational code?
Answer To update operational code when the 2212 is operating normally:
1. Access the OPCON prompt ( * ). See “Accessing the OPCON
Command Line Interface” on page A-3.
2. From the OPCON prompt (*), type talk 6 and press Enter to reach
the
Config
>
prompt. If the
Config
>
prompt does not appear, press
Enter again.
3. At the Config> prompt, type boot. The Boot config> prompt will be
displayed.
4. At the Boot config> prompt, type TFTP get load mod to get an
operational load image from a server to the IBM 2212. See “TFTP
File Transfer using the Operating Software” on page A-22 for
instructions on using TFTP. The operational code on the hard file or
compact flash will be updated.
A-24
2212 Install and Initial Config