IBM IBM 2212-40H, Руководство по установке и первоначальной настройке

Страница: 44 / 90

2. Press and hold the space bar when you see the message
Please press the space bar to obtain the console . The
console will display the following message:
‡ —
Please press the space bar to obtain the console.
Console granted to this interface
Space bar was pressed during IPL.
Do you wish to enter the service menu?(Y/N)
(in 10 seconds, N will be defaulted)
Service Console
svc>
ˆ ˜
3. Press y within 10 seconds.
To display a list of available commands, type ? at the
SVC>
prompt.
Adapter Tasks
Adapter Status / LED States
Question How do I check the state of the adapters in my IBM 2212?
Answer LEDs on the front and rear of the IBM 2212 indicate the status of the
adapter. (See “Adapter Port LEDs” on page 2-6 and “Additional
Slot-Status LEDs” on page 2-8.) The
Maintenance Guide treats problem
determination in more detail.
Adding an Adapter After Initial Configuration
Question How do I add an adapter after the IBM 2212 has been initially
configured?
Answer Install the adapter using the instructions accompanying the feature.
Either use the Configuration Program and download the updated
configuration to the 2212, or follow these steps to configure adapters
using the 2212’s OPCON command line interface (
*
prompt). (The
section on FRU exchange in the IBM 2212 Service and Maintenance
Manual describes the removal and replacement procedure.) Then:
1. Access the OPCON command line interface ( * prompt). See
“Accessing the OPCON Command Line Interface” on page A-3.
2. Type talk 6 and press Enter to reach the
Config
>
prompt. If the
Config
>
prompt does not appear, press Enter again.
3. Enter add device type of device.
To see a list of device choices, type add device ?.
The following two steps do not apply when a dial-circuit device is
being added.
| 4. Enter the device slot number. If you add a PMC adapter or
| configure a Model 10F or 10H, you will not be prompted for a slot
| number.
5. If you are adding an interface on a single-port adapter, go to step 6
on page A-7. Otherwise, continue with this step.
A-6
2212 Install and Initial Config