If you copy an image, the same rules apply except that image files can
be copied only from bank to bank. These steps describe how the copy
of an image affects the image that was previously in the bank:
1. The copy overwrites the image that was previously in the bank.
2. The copy acquires the status of the image that was previously in the
bank.
Erasing Files
Question How do I erase the contents of a bank in the 2212?
Answer
To erase a file, at the
Boot config
>
prompt or the
SVC>
prompt, type
erase, and then follow the prompts.
If you select a file to erase with a status of CORRUPT or NONE, the
erase option is discontinued.
Note that the following rules apply to erasing files from the IBM 2212:
¹
Image files that are not ACTIVE can be erased anytime
¹
ACTIVE image files
cannot be erased
¹
ACTIVE configuration files
cannot be erased
Getting a Configuration File from a Workstation to the 2212
Question How do I get a file from the workstation on which the configuration
program is running to the 2212?
Answer
To get a configuration file from the workstation on which the
configuration program is running to the 2212, you have the following
options:
¹
Attach the workstation to an IP network that can be used to reach
the 2212.
In this case, the workstation must be running TCP/IP and the
communications feature of the configuration program is used to
establish direct communications between the configuration program
and the 2212. When you use the Send option of the configuration
program’s communications feature, the configuration data is sent to
the 2212 using SNMP packets. After all of the configuration data
has been sent, you can use the communication feature’s restart
router option. This causes the 2212 software to be reloaded and
initialized using the new configuration data immediately. Alternately,
you can use the communication feature’s timed config option to set
a time when the 2212 will be reloaded with the new configuration.
¹
Attach the workstation to the same IP network as the 2212. In this
case, the workstation must be running TCP/IP and support TFTP in
addition to the configuration program. To transfer a configuration file
from the workstation to the 2212, see “Transferring Files Using
TFTP” on page A-21.
¹
Attach the workstation to the 2212's service port. In this case, you
can either use TFTP over SLIP (which requires TCP/IP to be
running on the workstation) or Zmodem to transfer to the 2212
configuration files which were created by the configuration program
A-20
2212 Install and Initial Config
Содержание IBM 2212-40H
