IBM eserver pSeries 7311 D10, Руководство по обслуживанию

Страница: 130 / 208

1 Model D20 Subsystem 4 Stabilizing Bar
2 19-Inch Rack 5 Front Rack Door
3 Extension Rail Safety Release Latch 6 System Drawer Release Latch
After completing the service actions, return the Model D20 subsystem to the operating position.
D20 Operating Position
To return your Model D20 subsystem to the operating position, do the following:
1. Release the rail release latches located on each rail. See the illustration on page 114 for the location
of the release tabs.
Note: To release the left rail, pull the release latch up. To release the right rail, push the right latch
down.
2. Release latches must be in the open position. See the illustration on page 114 for the location of the
subsystem release latches.
3. Push the system drawer straight back into the rack until both release latches on the subsystem have
locked into position.
4. If you removed two thumbscrews from the front bezel, replace them at this time.
5. Close the front rack door.
114 Eserver
pSeries 7311 Model D10 and Model D20 Service Guide