IBM eserver pSeries 690, Руководство по установке, Страница: 47 / 142

Go to “Running System Verification”.
Note: If you are unable to load standalone diagnostics, call your support center for
assistance.
Running System Verification
Before you run system verification, the diagnostics must have been loaded. For
information about how to load diagnostics, see Chapter 3, “Verifying the Hardware
Operation” on page 27.
R
1 2
5
3
4
6
!
1 Power on/off button 4 Reset button
2 Power on/off LED 5 Service processor reset
button (Service use only)
3 Operator panel displa 6 Disturbance or system
attention LED
When the Diagnostic Operating Instructions display, do the following to run system
verification:
1. Press Enter.
2. If the terminal type is requested, you must use the Initialize Terminal option on the
Function Selection menu to initialize the operating system before you can continue
with the diagnostics.
3. Select the System Verification option on the Diagnostic Mode Selection menu.
4. To run a general checkout of all installed resources, select the All Resource option
on the Diagnostic Selection menu. Follow the instructions on the screen to complete
the checkout procedure.
To check one particular resource, select that resource on the Diagnostic Selection
menu.
The checkout program ends with either of the following results:
v
The Testing Complete screen displays a message stating
No trouble was found
.
v
The A Problem Was Detected On (Time Stamp) menu displays, with either a service
request number (SRN) or an error code. Make a note of any codes displayed on the
display or operator panel.
Chapter 3. Verifying the Hardware Operation
31