IBM eserver pSeries 690, Руководство по установке

Страница: 130 / 142

d. Rotate the release levers down on each side of the BPR.
e. Repeat for the other BPRs. There can be up to six BPRs, with three in front and
three in back.
9. Install the Bulk Power Controllers (BPCs) as follows:
a. Push the BPC straight into the Bulk Power Enclosure (BPE).
b. Tighten the thumbscrew on each side of the BPC, using the torque tool (pat
number 6422789).
c. Repeat for the other BPCs. There are two BPCs, with one in front and one in
back.
10. Install the BPDs as follows:
a. Push the BPD straight into the Bulk Power Enclosure (BPE).
b. Tighten the thumbscrew on each side of the BPD, using the torque tool (pat
number 6422789).
c. Repeat for the other BPDs. There can be up to four BPDs, with two in front
and two in back.
11. Install the BPFs (Item 5 in the illustration on page 113) as follows:
Note: A grille covers the fan on the front of the fan assembly.
a. Locate the BPF to be installed.
b. Install the fan cover plate (Item 6 in the illustration on page 113).
c. Push the BPF straight out of the BPE.
d. Tighten the upper and lower fasteners, using the torque tool (part number
6422789)..
e. Repeat for the other BPF. There are two BPFs, one in front and one in back.
12. Install any front and rear bulk power fillers.
114
Eserver
pSeries 690 Installation Guide