IBM eserver pSeries 690, Руководство по установке

Страница: 59 / 142

Appendix D. Securing the Rack
This appendix contains information about installing the rack for the pSeries 690. This
procedure is optional and should be performed if the customer has ordered the
appropriate hardware kits to bolt the system to the floor. For further information, refer to
part number 44P0159, the installation instructions for RPQs 8A1183, 8A1185, 8A1186
as follows:
v
RPQ 8A1183 for attaching the rack-mounting plates to the concrete floor (non-raised
floor)
v
RPQ 8A1185 to attach the rack to a concrete floor when on a raised floor (9-1/2
inches to 11-3/4 inches high)
v
RPQ 8A1186 to attach the rack to a concrete floor when on a raised floor (11-3/4
inches to 16 inches high)
Positioning the Rack
Note: The customer should unpack the rack and position it in the room. If this has not
been done, consult the customer and the marketing representative as necessary.
To unpack and position the rack, do the following:
1. Remove all packing and tape from the rack.
2. Position the rack according to the customer floor plan.
3. Lock each caster wheel by tightening the thumbscrew on the caster.
Thumbscrew
Installing the Frame Kit
The following tables show the parts required for each of the tie-down kits (a non-raised
floor, short-raised floor, and a long-raised floor).
Rack Tie-Down Kits
11P4759 Frame Tie-down Kit (Non-Raised Floor) (RPQ 8A1183)
Item Part Number Qty Description
Item 3 in illustration on page
46. 11P3527 2 Shipping bar (lower)
Item 5 in illustration on page
46. 11P3529 4 Hinge plate
43