IBM eserver pSeries 690, Руководство по установке

Страница: 61 / 142

Item 9 in illustration on
page 46. 1621546 8 Screw (hex, 25mm, long, hinge)
Item 10 in illustration on
page 46. 1622307 8 Washer (M-8, hinge)
11P4758 Frame Tie-down Kit (Long-Raised Floor) (RPQ 8A1186)
Item Part Number Qty Description
Illustration on page 56. 44P0674 4 Turnbuckle Assembly (long)
Item 3 in illustration on
page 46. 11P3527 2 Shipping bar (lower)
Item 5 in illustration on
page 46. 11P3529 4 Hinge plate
Item 8 in illustration on
page 46. 11P3530 2 Latch plate
Item 6 in illustration on
page 46. 11P3531 2 EQ support
Item 2 in illustration on
page 46. 11P3532 2 Shipping bar (upper)
Item 7 in illustration 46. 76X4687 2 Latch bolt
Item 1 in illustration on
page 46. 1624804 20 Screw (hex flange, 20mm, long)
Item 9 in illustration on
page 46. 1621546 8 Screw (hex, 25mm, long, hinge)
Item 10 in illustration on
page 46. 1622307 8 Washer (M-8, hinge)
Mounting Internal Rack Components
To mount the internal rack components, do the following:
Attention: This procedure is performed by the service representative.
1. Using four M-8 (20 mm) screws (item 1 in illustration on page 46), install the top
shipping bar (item 2 in illustration on page 46) at EIA unit location 32.
2. Using four M-8 screws (item 1 in illustration on page 46), install the bottom
shipping bar (item 3 in illustration on page 46) at EIA unit location 18.
3. Repeat steps 1and 2 to install shipping bars in the rear of the rack.
4. Attach the front top hinge (item 5 in illustration on page 46) on the vertical rail
(located approximately at EIA unit 29-30 on the vertical rail) with two 25 mm
screws (item 9 in illustration on page 46) and two washers (item 10 in illustration
on page 46).
5. Attach the front bottom hinge (item 5 in illustration on page 46) on the vertical rail
(located approximately on EIA unit 6-7 on the vertical rail) with two 25 mm screws
(item 9 in illustration on page 46) and two washers (item 10 in illustration on page
46).
Appendix D. Securing the Rack
45