IBM 884155U, Руководство пользователя

Страница: 42 / 210

Installing a hot-swap hard disk drive
The following notes describe the types of hard disk drives that the server supports
and other information that you must consider when installing a hard disk drive:
v
The server supports up to six 1-inch (26 mm) slim-high, 3.5-inch, hot-swap hard
disk drives in the standard hot-swap bays.
v
The hot-swap bays are arranged vertically in the standard hard disk drive cage;
the bay numbers are 0 through 5 (from bottom to top).
v For a list of supported options for the server, go to http://www.ibm.com/us/
compat/.
v
Inspect the drive tray for signs of damage.
v Make sure that the drive is correctly installed in the tray.
v
If the server has an optional RAID adapter, see the documentation that comes
with the adapter for instructions on installing a hard disk drive.
v All hot-swap drives in the server should have the same throughput speed rating;
mixing speed ratings might cause all drives to operate at the lower throughput
speed.
v To minimize the possibility of damage to the hard disk drives when you are
installing them in a rack configuration, install the server in the rack before
installing the hard disk drives.
v
You do not have to turn off the server to install hot-swap drives in the hot-swap
drive bays. However, you must turn off the server when performing any steps
that involve installing or removing cables.
v You can install three additional hot-swap hard disk drives in the server after you
install the 3-Pack Ultra320 Hot-Swap Expansion option. These drives are in the
optional hard disk drive cage. Connect the cable to J58 SCSI channel A on the
system board. See the instructions that are provided with the option for
installation instructions and additional information.
v
Some filler panels come with a slim filler.
v
The SCSI ID for each hot-swap hard disk drive is printed on the bezel.
The following illustration shows how to install a hot-swap hard disk drive.
Slim
filler panel
Hard disk drive
Drive tray
Drive tray handle
(in open position)
Complete the following steps to install a hot-swap hard disk drive:
1. Read the safety information beginning on page v and “Installation guidelines” on
page 11.
2. Remove the filler panel from one of the empty hot-swap bays.
3. Make sure that the tray handle is open; then, install the hard disk drive into the
hot-swap bay.
32
xSeries 236 Type 8841: Hardware Maintenance Manual and Troubleshooting Guide