IBM 884155U, Руководство пользователя

Страница: 55 / 210

8. Insert the new battery:
a. Hold the battery so that the larger side is facing up.
b. Place the battery into its socket, and press the battery down until it snaps
into place.
9. Reconnect the internal cables that you disconnected.
10. Connect all external cables and all power cords.
11. Reinstall the air baffle.
12. Reinstall the server cover. See “Completing the installation.”
13. Start the Configuration/Setup Utility program and set configuration parameters
as needed. See the User’s Guide on the IBM xSeries Documentation CD for
additional information about using the Configuration/Setup Utility program.
Completing the installation
To complete the installation, reinstall the bezel, reinstall the server cover, reinstall
the door, reconnect all the cables that you disconnected earlier, and for certain
options, run the Configuration/Setup Utility program. Follow the instructions in this
section.
Attention:
v For proper cooling and airflow, replace the server cover before or shortly after
turning on the server. Operating the server for extended periods of time (over 30
minutes) with the server cover removed might damage server components.
v
To ensure proper server operation, do not remove the air-baffle assembly from
the server except when installing or removing the components that are under the
air-baffle cover.
Note: If you have just connected the power cords to electrical outlets, you must
wait approximately 20 seconds before pressing the power-control button.
Chapter 3. Installing options
45