IBM 866441Y - Netfinity 5600 - 8664, Руководство по техническому обслуживанию аппаратной части

Страница: 105 / 276

.3/
Filler Panel: You can remove this filler panel and
install a third hot-swap power supply on power
supply bay 3.
.4/
Power Supply 2 Power Connector: The power
cord for power supply 2 connects here.
.5/
Power Supply 1 Power Connector: The power
cord for power supply 1 connects here.
.6/
DC Power Light: This light provides status
information about the power supply. During normal
operation, both the AC and DC Power lights are on.
For any other combination of lights, see “Power
supply LEDs” on page 195 for more information.
.7/
AC Power Light: This light provides status
information about the power supply. During normal
operation, both the AC and DC Power lights are on.
For any other combination of lights, see “Power
supply LEDs” on page 195 for more information.
Air circulation
The server and monitor produce heat. The server has one
or more fans that pull in fresh air and force out hot air.
The monitor lets hot air escape through vents. Blocking
the air vents can cause overheating, which might result in
a malfunction or damage. Place the server and monitor so
that nothing blocks the air vents; usually, 15 cm (6 inches)
of air space is sufficient. Also, make sure the vented air is
not blowing on someone else.
Before you begin installing options
Before you begin to install options in the server, read the
following information:
Netfinity 5600 - Type 8664
97