IBM 866441Y - Netfinity 5600 - 8664, Руководство по техническому обслуживанию аппаратной части

Страница: 122 / 276

Attention
Power cannot be restored to the adapter slot
if the tab is not lowered into place.
d. Close the adapter retainer flap
.4/
.
10. Connect any needed cables to the adapter.
Attention
Route cables so that the flow of air from the fans
is not blocked.
11. Enable the PCI slot from the operating system.
(Refer to the documentation that comes with the
operating system for information about enabling a
hot-plug PCI slot.) Make sure that the Power light
.6/
for the hot-plug PCI slot is on.
12. If you have other options to install or remove, do so
now; otherwise, go to “Completing the installation” on
page 141.
Installing a non-hot-plug adapter
This section
gives the procedure for installing a non-hot-plug adapter.
If you want to remove a non-hot-plug adapter, reverse the
steps.
Before you begin:
Ÿ
Read “Safety information” on page 230.
Ÿ
Read the documentation that comes with the
option.
Refer to the illustrations in “Installing a hot-plug PCI
adapter” on page 110 while you perform the steps in this
procedure.
To install a non-hot-plug adapter:
1. Turn off the server and peripheral devices and
disconnect all external cables and power cords (see
“Preparing to install options” on page 100); then
remove the cover. See “Removing the left-side cover
(tower model)” on page 103 or “Removing the cover
(rack model)” on page 104.
2. Determine which PCI adapter expansion slot you will
use for the adapter.
Note
Check the instructions that come with the adapter
for any requirements or restrictions.
3. Remove the expansion-slot cover
.1/
:
a. Rotate the adapter retention latch
.3/
counterclockwise.
b. Remove the expansion-slot cover from the
server. Store it in a safe place for future use.
114
Netfinity Server HMM