IBM 8500R - Netfinity - 8681, Руководство по техническому обслуживанию аппаратной части

Страница: 27 / 290

Accessing server programs
After you start the server, several prompts appear on the
IBM logo screen.
Ÿ
To access the Configuration/Setup Utility program,
press F1 when the prompt
Press F1 for
Configuration/Setup
appears. See “The
Configuration/Setup Utility program” on page 20 and
“Using the Configuration/Setup Utility main menu” on
page 21 for additional information.
Ÿ
To access the Diagnostic Utility program, press F2
when the prompt
Press F2 for Diagnostics
appears.
For information on running the diagnostics programs,
see “Diagnostic programs” on page 10.
Ÿ
To access the utility programs in the System Partition,
press Alt
+
F1 when the prompt
Press Alt
+
F1 for
System Partition Boot
appears. See “Using the
System Partition” on page 33 for additional
information.
The IBM logo screen is similar to the following illustration.
Note
The screen might look slightly different, depending on
the BIOS version that comes with the server, and the
hardware configuration.
IBM Netfinity BIOS - Copyright IBM Corporation © 1999
Press F1 for Configuration/Setup
Press F2 for Diagnostics
Press ALT-F1 for System Partition Boot
>> Build ID - MMKT16AUS, BIOS Revision 1 <<
SMP system 4 processor(s):
BSP is processor A1 and APs are A2, A3, A4.
Pentium III Xeon ™ 550MHz
Configuration overview
You play a key role in how the server allocates resources
to organize and interconnect hardware devices and
software programs. This allocation process is referred to
as
configuration. The steps required to configure the
server depend on the number and types of devices and
programs that you install.
The server supports PCI adapters and SCSI devices.
Because of this flexibility, you can choose from among
many adapters and devices.
In general, the greater the number and variety of hardware
devices and software programs that you install in the
Netfinity 8500R - Type 8681
19