IBM 8500R - Netfinity - 8681, Руководство по техническому обслуживанию аппаратной части

Страница: 64 / 290

Completing the installation
Depending on the options that you have installed, you
must reinstall the top cover and the front bezel to complete
the installation. You must also reconnect all the cables
that you disconnected in “Preparing to install options” on
page 134, and, after installing certain options, you must
run the Configuration/Setup utility program. Follow the
instructions in this section.
Installing the top cover
Notes
1. The top cover is in place during normal
operation. If the server is on, do not leave the
top cover off for more than 30 minutes at a time.
2. If necessary, see “Input/output connectors and
expansion slots” on page 122 for connector
locations.
To install the server top cover:
1. Before installing the top cover, check that all cables,
adapters, and other components are installed and
seated correctly and that you have not left tools or
loose parts inside the server.
2. Place the cover-release latch
.1/
in the open (up)
position.
3. Insert the bottom tabs of the cover
.2/
in the
matching slots in the server chassis.
4. Close the cover-release latch to pull the cover forward
and lock the cover in place.
56
Netfinity Server HMM