IBM 8500R - Netfinity - 8681, Руководство по техническому обслуживанию аппаратной части

Страница: 121 / 290

controller is 7. The default SCSI ID for the SCSI
backplane is 15.
Termination:
All the internal hot-swap drives in the
server have automatic termination.
Preinstallation steps:
Before you install drives in
the server, verify that you have all the cables and any
other equipment specified in the documentation that comes
with the internal drive. You might also need to perform
certain preinstallation activities. Some of the steps are
required only during the initial installation of an option.
1. Choose the bay in which you want to install the drive.
2. Verify that all jumpers are removed from the drive.
3. To install the drive, continue with “Installing or
replacing a drive.”
Installing or replacing a drive
Notes
1. You do not have to turn off the server to install
hot-swap drives in these bays. If these bays are
not connected to a ServeRAID adapter, shut
down and restart the server. If these bays are
connected to a ServeRAID adapter, you can use
the RAID management software to bring the
drives online.
Refer to the ServeRAID adapter option
documentation for instructions on installing a
ServeRAID adapter.
2. You do not have to turn off the server to remove
a drive from a hot-swap bay, when that bay is
connected to a ServeRAID adapter.
If the amber hard disk status light for a drive is lit
continuously, that individual drive is defective and needs to
be replaced. For additional information, see “Internal
drives installation” on page 110. For the location of the
hard disk status light, see “Controls and indicators” on
page 60.
Netfinity 8500R - Type 8681
113