IBM 783722U, Инструкция по установке и эксплуатации

Страница: 82 / 154

To install a hot-swap hard disk drive, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 32.
2. Unlock the left-side cover.
3. Open the bezel. (see “Removing the bezel” on page 36).
4. Place your finger on the pull point area on the left side of the bezel door and
rotate it away from the server.
Note: After you rotate the bezel beyond 90°, you can pull the bezel off the
server and set it aside, if you want to remove it completely.
5. Remove the EMC shield from the bay in which you want to install the drive.
6. Touch the static-protective package that contains the drive to any unpainted
metal surface on the server; then, remove the drive from the package and place
it on a static-protective surface.
7. Install the hard disk drive in the hot-swap bay:
a. Make sure that the drive tray handle is open.
b. Align the drive assembly with the guide rails in the bay.
The following is the 2.5-inch hot-swap model:
64
System x3400 M2 Types 7836 and 7837: Installation and User’s Guide