IBM 7378, Руководство по диагностике и обслуживанию

Страница: 312 / 362

Removing a microprocessor retention module
To remove a microprocessor retention module, complete the following steps:
1. Read the safety information that begins on page vii and “Handling
static-sensitive devices” on page 151.
2. Turn off the server and all attached devices; then, disconnect all power cords
and external cables.
3. Carefully turn the server on its side so that it is lying flat, with the cover facing
up.
Attention: Do not allow the server to fall over.
4. Unlock and remove the left-side cover (see “Removing the left-side cover” on
page 181).
5. Remove the power supply or power supplies from the power-supply cage (see
“Removing a hot-swap power supply” on page 273).
6. Rotate the power-supply cage to its open position (see “Opening the
power-supply cage” on page 154).
7. Remove the air baffle (see “Removing the air baffle” on page 212).
8. Remove the heat sink and the microprocessor (see “Removing a
microprocessor and heat sink” on page 284).
9. Using a T8 Torx screwdriver, remove the four screws that secure the
microprocessor retention module to the system board; then, lift the
microprocessor retention module from the system board.
10. If you are instructed to return the microprocessor retention module, follow all
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
294
IBM System x3400 M3 Types 7378 and 7379: Problem Determination and Service Guide