IBM 7378, Руководство по диагностике и обслуживанию

Страница: 254 / 362

Installing a USB embedded hypervisor flash device
To install a hypervisor flash device, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 149.
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover (see “Removing the left-side cover” on page 181).
4. Unlock the retention latch by pushing it down toward the system board.
5. Align the flash device with the USB connector on the system board and push it
into the USB connector until it is firmly seated.
6. Return the retention latch to the locked position by pulling it away from the
system board.
7. Reconnect the power cord and any cables that you removed.
8. Install the cover (see “Installing the left-side cover” on page 181).
9. Turn on the peripheral devices and the server.
Removing an optional ServeRAID adapter advanced feature key
To remove an optional ServeRAID adapter advanced feature key, complete the
following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 149.
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover (see “Removing the left-side cover” on page 181).
4. Rotate the adapter-retention brackets to the open position.
236
IBM System x3400 M3 Types 7378 and 7379: Problem Determination and Service Guide