IBM 4247 - Model 001 B/W Dot-matrix Printer, Руководство пользователя

Страница: 77 / 454

Path Function
When no paper is in the current path and the printer is in the not ready state,
pressing Park/Path allows the selection of the different paper paths available on
the printer. When the desired path is displayed, press Start. The paper path
displayed becomes the active paper path and the printer becomes
ready. You can
also press Load/Eject or Form/Feed for continuous forms to select the active
paper path.
The paper path selected by Park/Path also becomes the current value for Paper
Source in the Printer Setup category. See “Paper Source” on page 10-2.
Line Feed
L i n e
F e e d
This function is valid only when the printer is not ready.
Press Line Feed to cause the printer to advance the forms one print line based on
|
the current LPI setting. If you hold Line Feed more than four seconds, the forms
move continuously until you release the key.
Similar to the forms advance knob on other printer products, the Line Feed key
allows coarse vertical movement of forms. This key does not function as an “Index”
key, which may be found on other printer products.
Note: If you use this key when the Processing indicator is blinking, the top of
form position could become misaligned.
Load/Eject
L o a d /
E j e c t
The Load/Eject function depends on what active form path you have selected. This
section describes the function for each of the paper paths.
Front Push and Rear Push:
The Load/Eject key performs the following functions:
Ÿ Automatically loads forms
After the forms are loaded under the sensor and onto the tractors at the bottom
of the forms device press Load/Eject to automatically load the forms to the top
of form position.
Ÿ Moves forms to the tear-off position
Do not press Stop first.
Chapter 2. Understanding the Operator Panel
2-13