2-2
GROUP 2 REMOVAL AND INSTALLATION OF UNIT
1. MAST
REMOVAL
1)
Remove and install following units as explained in the flow chart.
Forks
Lower the fork carriage until the forks are
approximately 25mm(1in) from the floor.
Pull up the knob and slide one fork at a
time toward the center of the carriage
where a notch has been cut in the bottom
plate for easy fork removal.
Remove only one fork at a time.
On larger forks it may be necessary to
use a block of wood.
(1)
①
②
③
※
Center notch
Roll pin
Knob
Spring
Pin
Fork
Carriage
Backrest
60L7ARE04
Backrest
(If necessary)
Remove bolts securing backrest to fork
carriage, lift backrest straight up and
remove it from carriage.
(2)
①
Carriage
Backrest
Bolt
60L7ARE05
Carriage
With the mast vertical, raise the carriage
high enough to place blocks under the
load forks. This is done to create slack in
the load chains when the carriage is
lowered. Lower the carriage all the way
down to the floor. Make sure the carriage
is level, this will prevent any binding when
the mast is raised.
(3)
①
Block
Crane
60L7ARE53
Содержание 60L-7A
