3-51
Install differential assembly into the carrier.
Place the bearing cup and screw into the
housing. At this moment, using a screw
adjust rotation backlash.
Install the dial gauge on the gear tooth and
measure the backlash while rotating bevel
gear.
·
Rotation backlash : 0.18~0.23
mm
(0.007~0.009
in
)
(5)
Assemble bearing cap.
Fix bearing cap with hexagon bolt.
·
Tightening torque : 15.0~17.0
kgf
·
·
m
(108~123
lbf
·
ft
)
Measure rolling resistance of tapered
roller bearing.
The following table shows the
relation between preload(P) of bevel
pinion shaft and rolling
resistance(Z).
(calculated at adjustment of pinion
(6)
※
Confirm that the screw contacts to the bearing.
After complete assembly of bearing, measure rotation backlash once more and readjust with a
screw if needed.
Apply loctite #271 to the thread of bearing cap bolt and then assemble it with tightening torque of
15.0~17.0
kgf
·
m
(108~123
lbf
·
ft
).
Assemble plate with hexagon bolts. Apply loctite #271 or #277 to the tapped side of bolt and then
assemble it with tightening torque of 0.80~1.20
kgf
·
m
(5.8~8.7
lbf
·
ft
).
Assemble opposite side with the same methods.
Apply marking liquid on 3~4 teeth of the ring gear and then rotate pinion gear to check gear
contact. Check out the contacted shape.
(7)
(8)
(9)
(10)
※
(11)
50D7EDA41
P
0.20(1.45)
0.25(1.81)
0.30(2.17)
0.35(2.53)
Z
0.30~0.36(2.17~2.60)
0.35~0.41(2.53~2.97)
0.40~0.46(2.89~3.33)
0.45~0.49(3.25~3.54)
Unit : kgf
·
m (lbf
·
ft)
Содержание 60L-7A
