2-4
Piping
Remove the return hoses and clamps
attached to the cylinder.
Remove the return hose from the tee.
Remove hose assembly, tee and down
safety valve(1).
Put blind plugs in the piping immediately
after removing hoses.
This prevents the hydraulic oil from
flowing out and also prevents dust and
dirt from getting in.
(4)
①
②
③
※
Hose
clamp
1
Return
hose
Lift
cylinder
60L7ARE09
Lift cylinder
Loosen and remove hexagon bolts and
washers securing lift cylinders to inner
mast.
Bind the lift cylinder with overhead hoist
rope and pull up so that the rope has no
slack or binding.
Make sure the lift cylinder be
tightened firmly for safety.
Loosen and remove hexagon bolts, nuts
and clamp securing lift cylinders to outer
mast.
Using an overhead hoist, slowly raise the
inner mast high enough to clear lift
cylinder.
Using an overhead hoist, draw out lift
cylinder carefully and put down on the
work floor.
(5)
①
②
③
④
⑤
Inner
mast
Outer
mast
Lift
cylinder
Clamp
Bolt
Nut
60L7ARE10
Содержание 60L-7A
