Hyundai 60L-7A, Руководство пользователя

Страница: 75 / 217

3-34
For the other side of the counter shaft
assembly, follow the procedure in steps 5
through 8.
Put clean transmission oil on each side of
the clutch plates and clutch discs. Install
four 2T clutch plates, three 4T clutch plates,
five clutch discs and one bending plate in
the cylinder with the following procedure.
First, install a 4T cluch plate (56).
Install a 4T clutch plate, then install a
bending plate (59). In following procedure,
bending plate shape will be downward.
Follow steps (1) and (2) again until all of
four the 2T clutch plates (57) and discs
(58) are installed in the cylinder.
Next, install a clutch disc that has teeth on
its inside diameter.
Finally, Install a clutch plate first, that has
guide shape on its outside diameter.
15)
16)
(1)
(2)
(3)
(4)
(5)
Use a screwdriver and install snap ring (55)
that check all of them in position in the
cylinder.
Install three seal rings on the shaft.
Be careful not to cause damage to the seal
rings.
Install thrust washer and needle bearings
on the counter shaft of high speed clutch
side.
17)
18)
※
19)
35L7ADA40
Install gear (56), thrust washes (55) and
bearing cone (54) with tool.
Do not use force to install the gear.
Move the gear backward and forward while
the gear is pushed into the clutch assembly
until the teeth on the clutch discs are in
alignment with the splines on the gear. 20)
※
50DFTM35
56
55
59
58
57