HYOSUNG GT 650, Руководство по обслуживанию

Страница: 76 / 210

3-35 ENGINE
◉
GEARSHIFT SHAFT
Disassemble and reassemble the gearshift shaft as
shown in right picture.
■
REASSEMBLY
Assemble the countershaft and drive shaft in the reverse
order of disassembly. Pay attention to following points :
◉ TRANSMISSION
■
INSPECTION
★ GEAR-SHIFTING FORK
Using a thickness gauge, check the clearance between
in the groove of its gear and shifting fork.
The clearance for each of the three shifting forks plays
an important role in the smoothness and positiveness of
shifting action.
If the clearance checked is noted to exceed the limit
specified, replace the fork or its gear, or both.
Service limit
0.5 mm
(0.020 in)
Standard
0.10~0.30 mm
(0.004~0.012 in)
Thickness gauge : 09900-20806
Vernier calipers : 09900-20101
Shift fork-groove
clearance
Shift fork groove width
Standard
NOTE
Before installing the gears, coat lightly engine oil
to the driveshaft and countershaft.
NO.3
NO.1 & NO.2
4.85~5.00 mm
(0.191~0.197 in)
4.85~5.00 mm
(0.191~0.197 in)
Shift fork thickness
Standard
NO.3
NO.1 & NO.2
5.3~5.4 mm
(0.209~0.213 in)
5.3~5.4 mm
(0.209~0.213 in)