hymer ERIBA Touring 2012, Инструкция по эксплуатации

Страница: 92 / 158

92
Touring - 04/11-1 - englisch (EN) - 2048869 - HYW-0102-09EN
9 Appliances
Switching off:
„
Set the flip switch (Fig. 79,1) to " ". The indicator lamp on the switch goes
off.
Combined operation The water is heated more quickly in the boiler if gas operation and 240 V elec-
trical operation are switched on simultaneously.
Filling/emptying the boiler The boiler can be supplied with water from the water tank.
Depending on the model, the vehicle is fitted with one or several boiler drain
cocks. The drain cocks can have different designs (rocking lever or twist cap).
Filling the boiler with water:
„
Close all boiler drain cocks. To do this, position the rocking lever (Fig. 80,1)
horizontally or turn the cap (Fig. 80,2) in a clockwise direction.
„
Set all the water taps to "Hot" and open them. The water pump is turned
on. The warm water pipes are filled with water.
„
Keep the taps open until the water flowing out of the taps has no bubbles
in it. This is the only way to ensure that the boiler is full of water.
„
Close all water taps.
Emptying the boiler:
„
Set the rotary switch (Fig. 78,3) on the operating unit (Fig. 78) to " "
(Fig. 78,4) or the flip switch (Fig. 79,1) to " ".
„
Turn knob (Fig. 78,1) anticlockwise until it can go no further.
„
Open all boiler drain cocks. To do this, position the rocking lever (Fig. 80,1)
vertically or turn the cap (Fig. 80,2) in an anticlockwise direction.
„
Check whether the water has been drained completely from the boiler
(approx. 12.5 litres).
9.3.3 Hot water source
Z
Further information can be obtained in the manufacturer's instruction
manual.
Fig. 80 Drain cocks
Z
Never use the hot water source without water inside it.
Z
If the hot water source is not being used, empty it if there is any risk of frost.
Z
Switch off the hot water source and empty it if the vehicle is not used.
Z
Do not fit a check valve in the cold water pipe between the hot water source
and the water pump.
Z
Use a pressure reducer when connecting to a central water supply or with
strong pumps. The hot water source is designed only for pressures of up
to 1.2 bar. In addition, insert a safety/drainage valve in to the cold water
pipe.