hymer ERIBA Touring 2012, Инструкция по эксплуатации

Страница: 120 / 158

120
Touring - 04/11-1 - englisch (EN) - 2048869 - HYW-0102-09EN
12 Customer service and maintenance
12.3.2 AKS 1300
Checking the stabilising
device (on the side of the
friction pads)
Prerequisite: Connection to AKS 1300, ball diameter 50 mm
„
Turn the handwheel (Fig. 97,1), until it can be heard and felt that the torque
limiting mechanism grates. Direction of rotation: In a clockwise direction.
„
Check distance a:
z
Distance a > 0 (Fig. 97): Wear within the permissible range.
z
Distance a = 0 (Fig. 98): Check and, if necessary, replace the friction
pads.
12.3.3 WS 3000 D
Checking the stabilising
device (on the side of the
friction pads)
Prerequisite: Connection to WS 3000, ball diameter 50 mm
„
Activate the stabilising mechanism. To do this, press the coupling handle
downwards (Fig. 99,2) from the closed position (Fig. 99,1) to its stop limit.
A wear indicator (Fig. 100) with a bar diagram (Fig. 100,1) is attached on the
coupling handle.
z
When the pin (Fig. 100,2) is in the longitudinal hole at the marking with the
"+", the friction pads are still in good condition.
z
When the pin is at both centre markings, the friction pads are slightly worn.
z
When the pin is at the marking with the "–", the friction pads are worn and
must be replaced.
Fig. 97 Friction control Fig. 98 Friction control
Z
Resetting the friction pads is not required.
Fig. 99 Stabilising handle Fig. 100 Wear indicator