hymer ERIBA Touring 2012, Инструкция по эксплуатации

Страница: 102 / 158

102
Touring - 04/11-1 - englisch (EN) - 2048869 - HYW-0102-09EN
10 Sanitary fittings
10.4 Filling the water system
Models with water
canister
With models with water canister, fill the water system as follows:
„
Position the vehicle horizontally.
„
Clean or disinfect water system.
„
Loosen retaining straps at the water canister.
„
Unscrew the cap of the water canister.
„
Remove water pump and water hose from the water canister.
„
Replenish drinking water.
„
Place water pump in the water canister and close the cap tightly.
„
Secure water canister with retaining strap.
„
Connect the 240 V power supply and switch on the 240 V automatic circuit
breaker.
„
Set all the water taps to "Hot" and open them. The water pump is turned
on. The warm water pipes are filled with water.
„
Keep the taps open until the water flowing out of the taps has no bubbles
in it. This is the only way to ensure that the boiler is full of water.
„
Set all water taps to "Cold" and leave them open. This will fill the cold water
pipes with water.
„
Keep the taps open until the water flowing out of the taps has no bubbles
in it.
„
Close all water taps.
Models with water tank With models with water tank, fill the water system as follows:
„
Position the vehicle horizontally.
„
Connect the 240 V power supply and switch on the 240 V automatic circuit
breaker. If the vehicle is equipped with a self-sufficiency package with bat-
tery, it is not necessary to connect it to a 240 V power supply.
„
Close drain cocks for the boiler or hot water source and cold water source.
X
When filling the water tank, observe the maximum permissible gross
weight of the vehicle. Luggage must be reduced accordingly when the
water tank is full.
Z
The water pump will overheat without water and can get damaged. Never
operate water pump when the water canister or the water tank is empty.
Fig. 90 Water tank, stopper