HygroMatik FLE TSPA Series, Руководство пользователя

Страница: 51 / 94

Page 51
Continuation of SPA parameters
No. Parameter No. Meaning/comment
[ ] explains the term in the glossary
min max FP 
[ ] refers to a related term explanation
19 Supply_fan2_mode Operating mode of steam bath fan 2
0 Off Off
1 On Continuous operation, if unit control switch is in pos. "I"
2 Automatic Steam bath fan 2 runs during steam production and is switched off when (steam bath target
tempe steam bath fan 2_
∆ Temp.) has been reached
min max
FP
20 Supply_fan2_ ∆ temp. 0 5.0 .5 Temperature difference which must be achieved for steam bath fan 2 to be switched off
21 ∆ Temp._ECO 0 20.0 10.0 The temperature set value [3] is lowered by the amount entered in ∆ Temp._ECO [52] when
ECO is enabled
22 Correction_°C-signal 0 5.0 0 Used for the adjustment of the temperature sensor
23 Temperature_notification
0 90.0
45.0
Used to specify a temperature threshold value [88] in °C. When this is reached, a relay is
energised
24
Temperature_notification 0 134 113
Used to specify a temperature threshold value [88] in °F. When this is reached, a relay is
energised
25 Sensor 2_connection
Selection of the input for the connection of 2nd temperature sensor [45]

0 Off
Only 1 temperature sensor connected
1 Cylinder_extension 2nd temperature sensor connected to the expansion board
2 Relay_extension 1
2nd temperature sensor connected to the relay board
26 Temperature_measurement
Type of measurement processing

[45]
0 Average
Averaging the measurements of both temperature sensors
1 Deviation Error message in case of deviation
27 Sensor 1_weighting 0 100 Weighting of the measurements of both temperature sensors  [45]
28 Sensors_deviation 1.0 10.0 Specification of the deviation of temperature measurement 2 from temperature
measurement 1 at which an error message is to be triggered

[45]
Adjustment/value range
Factory presets (FP) bold