HYDAC FILTER SYSTEMS FAM-5-M-2-A-05-R-H-B-Z-1, Инструкция по эксплуатации и техническому обслуживанию

Страница: 51 / 100

Troubleshooting
FAM 5 en(us) 51 / 100
BEWA FAM5 3667663b en-us 2012-12-12.doc 2012-12-12
the fluid filter.
See page 76 for details.
5. Switch on the unit at the main switch and start the unit by
pressing the on switch.
-
>a. The unit starts and runs
normally. -> proceed to Step 100.
6.
-
>b. The unit stops after 3 seconds
and the "Fault / Unit off" signal
lamp comes on. -> proceed to Step 7.
7. Check the oil level in the oil pan.
-
>a. The float switch in the oil
collecting pan triggered due to
the oil. -> proceed to Step 9.
8.
-
>b. There is no oil/fluid in the oil
collecting pan. -> proceed to Step 12.
9. Look for and fix the leak immediately.
10. Empty the oil collecting pan. See page 57.
-
>a. The unit starts and runs
normally. -> proceed to Step 100.
11. -
>b.
The unit does not start and the
"Fault / Unit off" signal lamp
comes on. -> proceed to Step 12.
12. Check the oil level in the vacuum pump. See page 66.
-
>a. Oil level in the vacuum pump
outside the MIN / MAX
markings. -> proceed to Step 14.
13.
-
>b. Vacuum pump oil level OK.
Within the MIN / MAX mark. -> proceed to Step 17.
14. Fill the vacuum pump (see page 68 ) or drain the vacuum pump
oil slightly (see page 71).
15. Start the unit by pressing the on switch.
-
>a. The unit starts and runs
normally. -> proceed to Step 100.
16.
-
>b. The unit stops and the signal
lamp "Fault / Unit off" lights up. -> proceed to Step 17.
17. Check the vacuum column.
18.
-
>a. If the level of the vacuum
column is above the mark that
has been applied. -> proceed to Step 19.